進口不銹鋼磁力泵|進口磁力泵I：進口不銹鋼磁力泵概述：磁力泵由泵、磁力傳動器、電動機三部分組成。關鍵部件磁力傳動器由外磁轉子、內磁轉子及不導磁的隔離套組成。當電動機帶動外磁轉子旋轉時，磁場能穿透空氣隙和非磁性物質，帶動與葉輪相連的內磁轉子作同步旋轉，實現動力的無接觸傳遞，將動密封轉化為靜密封。由于泵軸、內磁轉子被泵體、隔離套*封閉，從而*解決了“跑、冒、滴、漏”問題，消除了煉油化工行業易燃、易爆、有毒、有害介質通過泵密封泄漏的安全隱患，有力地保證了職工的身心健康和安全生產。II：進口磁力泵的工作原理將n對磁體(n為偶數)按規律排列組裝在磁力傳動器的內、外磁轉子上，使磁體部分相互組成完整藕合的磁力系統。當內、外兩磁極處于異極相對，即兩個磁極間的位移角Φ＝0，此時磁系統的磁能zui低；當磁極轉動到同極相對，即兩個磁極間的位移角Φ＝2π/n，此時磁系統的磁能zui大。去掉外力后，由于磁系統的磁極相互排斥，磁力將使磁體恢復到磁能zui低的狀態。于是磁體產生運動，帶動磁轉子旋轉。III：進口不銹鋼磁力泵的優點介紹:磁力泵是一種通過磁力傳動器(磁力聯軸器)來實現無接觸力矩傳遞從而以靜密封取代動密封，使泵達到*無泄漏。由于泵軸、內磁轉子被泵體、隔離套*封閉，從而*解決了“跑、冒、滴、漏”問題，消除了煉油化工行業易燃、易爆、有毒、有害介質通過泵密封泄漏的安全隱患，有力地保證了職工的身心健康和安全生產。同使用機械密封或填料密封的離心泵相比較，磁力泵具有以下優點：1．泵軸由動密封變成封閉式靜密封，*避免了介質泄漏。2．無需獨立潤滑和冷卻水，降低了能耗。3．由聯軸器傳動變成同步拖動，不存在接觸和摩擦。功耗小、效率高，且具有阻尼減振作用，減少了電動機振動對泵的影響和泵發生氣蝕振動時對電動機的影響。4．過載時，內、外磁轉子相對滑脫，對電機、泵有保護作用。當磁力傳動器的從動部件在過載情況下運行或轉子卡死時，磁力傳動器的主、從動部件會自動滑脫，保護機泵。此時磁力傳動器上的永磁體在主動轉子交變磁場的作用下，將產生渦損、磁損，造成永磁體溫度升高，磁力傳動器滑脫失效。IIII：進口不銹鋼磁力泵參數進口14mm~100mm-出口10mm~80mm流量: 1.2m3/h-60m3/h級數: 2-10揚程: 5m-50m吸程: 3-6m轉速: 2900r/m電機功率: 0.12kw~18.5kw適用介質:酸，堿液，油類，稀有貴重液，鍍液，揮發性液體?電壓:220/380V材質:不銹鋼IIIII:不銹鋼磁力泵應用:不含固體顆粒腐蝕液體、強酸、強堿、乙醇、漂白劑、照相液、硝酸、鹽酸、氫氟酸、醋酸、氫氧化納、丙酮、四氧乙烷、海水、鹽水等The United States imports of stainless steel pump TYLER TaylorI: imported stainless steel magnetic pump overview:The magnetic pump consists of a pump, magnetic actuators, motors of three parts. Key components of magnetic actuator by the external magnetic rotor sleeve, inner magnetic rotor and non magnetic components.When the motor drives the outer magnetic rotor, the magnetic field can penetrate the air gap and non-magnetic material, driven by the magnetic rotor and impeller connected for synchronous rotation, to achieve non-contact power transmission, the dynamic seal into static seal. As the shaft, the rotor is within a magnetic pump, isolated sets of compley closed to compley solve the problem of "run, run, drip, leak, remove the oil refining chemical industry flammable, explosive, toxic and harmful media through the pump seal leakage security risks, effectively ensure the workers health and safety of.II: imported magnetic pump working principleN of the magnet (n is even) arranged according to the laws in the magnetic clutch assembly inside and outside the magnetic rotor, the magnet part consisting of magnetic coupling system. When the inside and outside the two poles in different relative displacements, two poles between the angle phi = 0, the lowest energy magnetic system; when rotates to the relative displacement of two poles, pole angle between phi = 2 pi /n, the maximum magnetic energy of magnetic system. Remove the external force, due to the magnetic system of magnetic poles repel each other, magnetic magnet will return to the lowest energy state. Thus, the magnet generates motion to drive the rotor to rotate.III: introduction of the advantages of imported stainless steel magnetic pump:Magnetic pump is a magnetic actuator (through magnetic coupling) to achieve non-contact torque transmission to replace the static seal dynamic seal, the pump compley without leakage. As the shaft, the rotor is within a magnetic pump, isolated sets of compley closed to compley solve the problem of "run, run, drip, leak, remove the oil refining chemical industry flammable, explosive, toxic and harmful media through the pump seal leakage security risks, effectively ensure the workers health and safety of.Compared with the centrifugal pump with mechanical seal or packing seal, the magnetic pump has the following advantages:1 pump shaft from the dynamic seal into a closed static seal, compley avoid the leakage of the media.2 no independent lubrication and cooling water, reducing energy consumption.3 by coupling drive into a synchronous drive, there is no contact and friction. The utility model has the advantages of low power consumption and high efficiency, and has the function of damping and damping, which reduces the influence of the motor vibration on the pump and the influence of the pump cavitation vibration on the motor.4 when the overload, the inner and outer magnetic rotor relative slip, the motor, pump protection.When the magnetic actuator driven components running in case of overload or rotor stuck, magnetic clutch master and slave unit will automatically slip to protect the pump. The magnetic drive permanent magnet on the rotor in the active role of the alternating magnetic field, will produce eddy loss, magnetic loss, resulting in permanent magnet temperature, magnetic clutch slip failure.IIII: imported stainless steel magnetic pump parametersImport 14mm~100mm- export 10mm~80mmFlow: 1.2m3/h-60m3/hSeries: 2-10Lift: 5m-50mSuction process: 3-6MSpeed: 2900r/mMotor power: 0.12kw~18.5kwSuitable medium: acid, alkali, oil, rare valuable liquid, plating liquid, volatile liquidVoltage: 220/380VMaterial: stainless steelApplication of IIIII: stainless steel magnetic pump:Not containing solid particles, corrosive liquid acid, alkali, alcohol, bleach, photographic liquid, nitric acid, hydrochloric acid and hydrofluoric acid, acetic acid, sodium hydroxide, four acetone, ethylene oxide, water, salt etc.